US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com some structural requirement. For example, and the shear stress, r, at any line q. either on, when located below the bore center line, more or at a distance from, the neutral axis of the space will be provided for an underslung recoil total section, is mechanism. Or, if they are located on the center line, structural symmetry is preserved. FrA d (14) Also, if the trunnions are on the center line, - - the sighting equipment will not have to be corrected for discrepancies due to an off-center where A. = area above the line q corctfo t = thickness of section at q location. iisd = distance between the neutral 42.

In the horizontal plane, it is advantage- axis of the section athe neu ous to have the trunnions located equidistant axis of a d the neu- from the center line of the gun bore. Here, the object is mainly one of symmetry. If sym- FT V. + F, resultant shear at metry cannot be achieved, the cradle will be the section (see Figures 8 and 9) subjected to a direct load and a couple equal to I = moment of inertia of the section the recoil force times the offset. Its vertical L = moment arm of trunnion meas- component 'ends to turn the weapon on its ured to center of bearing side. Its horto.ontal component tends to rotate M = FrL, bending moment the cradle and top carriage.

However, the base supporting the top carriage is symmetrical with respect to the bore and the loads revert to a G. STRENGTH REQUIREMENTS symmetrical condition at this point. If any 45. Stresses are calculated for a cradle which residual horizontal moment persists, it is is assumed to be completely isolated from all rsisted at the traversing gear. This dL- other components of the gun. This approach is cussion does not include the rifling torque conservative because the stiffness associated which is transmitted through the structure with gun tube and structural members which while the projectile travels in the bore. ordinarily would lend strength to the cradle 43.

When the distances from the bore to the is ignored. trunnions are unequal, the cradle must be 46. The general stresses of the main cradle made larger to offset the effects of the un- structure are due to bending and direct shear. symmetrical loads and this eventually leads to However, at each point of load application, a heavier structure. In considering deflections, local stresses are present which may be greater symmetry becomes definitely desirable. If than or may augment the general stress.

The both sides of the cradle deflect Nqually, com- local areas are loaded by the recoil mechanism, pensation for misalignment during firing pre- the trunnion, and the elevating mechanism snta lesser problems in fire control than if the through their attachments to the cradle. two sides of the cradle deflected unequally. After the principal stresses have been found, In the first case, the gun tube would remain usually by conventional methods of stress essentially in line, while in the latter, it would analysis, the equivalent stress is determined. turn slightly askew. An accepted method for computing the 44.

The size of the trunnion is usually dic- equivalent stress comes from the maximum- tated by required bearing dimensions. How- shear-stress theory of Tresca and Saint ever, it should be investigated to determine its Venant* which states that yielding begins when strength in bending and shear. As a rule, the the largest difference of two principal stresses trunnion may be considered a short beam and equals the yield strength of the material, or the stresses calculated according to the formu- las below, which can be found in any text on at - a2 = av (15) strength of materials.

The bending stress is To be compatible with other components of (MC the gun carriage, a factor of safety of 1.5 is rec- I3 * Reference 6, Page 39. 17 tV