US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com ommended for the cradle. Now, if al = or and where .E = modulus of elasticity ( o,= , the equivalent stress is p = pressure at interface due to" (15a) shrink fit r = radius at contact surfaces of con- The factor of safety is centric cylinders r = inner radius of inner cylinder r, = outer radius of outer cylinder = radial interference 1. Trunnion Hubs 48. The strength of the gusets supporting nions are either welded or bolted to the cradle. shown in Figure 19, the hub being assumed to 47. The hubs or sockets holding the trun- the hub is based on the loading arrangement Reinforcements at the hub are sometimes nee- be supported by the gussets only.

The load essary to distribute the loads and prevent lol distribution of the reactions Ro and R. is as- essryume tragua disriut the basds ann theen looad failure. If the trunnion shank fits the hub u trigular and is based on the load freely, the latter is stressed in shear and bend- paraliel to the cannon bore. ing. But, if the joint is a shrink fit, the inter- Each structural member, whether gusset or face pressure produces hoop stresses in the hub, must be statically balanced. Therefore, trunnion shank and the hub. This pressure is by isolating the hub found by equating the interference to the total R = F - A (17) deflection of the concentric cylinders at their n interface.

A, ~ 1a ThsrARA + cRa L (17a) Thus c = n EA / _ + r2 r + r,2\ where FA = ,unnion load parallel to bore r= / - r 2 - rI ' n = number of gussets parall lto FA F d TRUNNION ,--- GUSSET GUSSET---,LOA CENTER OF Re ICRADLE RR bLOAD CENTER FA = TRUNNION LOAD FARALLEL TO t. BORE Rc = SHEAR BETWEEN GUSSET AND CRADLE BODY Re = HORIZONTAL REACTION OF GUSSET, DISTRIBUTED Rh = SHEAR BETWEEN GUSSET AND HUB Rv = VERTICAL REACTION OF GUSSET, DISTRIBUTED Figure 19. Load Distribution on Trunnion Structure 18