Downloaded from https://www.everyspec.com MIL-HDBK-502: A MIL-HDBK-502: A CQUISITION CQUISITION L OGISTICS OGISTICS maintainability (RAM) community via industry standards, then the logistician should utilize it and not buy redundant data. On the other hand, some of the reliability and maintainability data a logistician would like to see may not be delivered to the RAM community. In this case, one of the LMI summaries, such as Maintenance Planning, could be utilized to get the necessary data. If RAM data is requested on this summary, the data should be in the same format and have the same definition that is specified in appropriate RAM standards.
This restriction precludes levying government-unique requirements on the contractor. The remainder of this section will focus on using the LMI performance specification as a source for support data. Remember, this specification is not the only source of support data. In fact, its specific definitions in Appendix B are mainly for provisioning, packaging, cataloging, and support equipment, but the LMI specification summaries can be used to obtain information in other support areas. 7.2 MIL-PRF-49506, LOGISTICS MANAGEMENT INFORMATION As a result of the Secretary of Defense’s policy on usage of specifications and standards, MIL-PRF-49506, LMI, has been developed to replace MIL- STD-1388-2B.
It is not a revision of MIL-STD-1388-2B. Rather, it represents a fundamental change in the way data requirements are levied on contracts. MIL-PRF-49506 does not contain any “how to’s.” The new specification is designed to minimize oversight and government-unique requirements. The underlying philosophy of MIL-PRF-49506 is to allow contractors maximum flexibility in designing systems and developing, maintaining, and providing support and support related engineering data. In order to achieve this objective, the new specification has the following characteristics: 1.
The principal focus of MIL-PRF-49506, LMI, is on providing DoD with a contractual method for acquiring support and support related engineering data. The Department of Defense uses this data in-house in existing DoD materiel management automated systems such as those for initial provisioning, maintenance planning, cataloging, support equipment data, and item management. 2. Data products intended primarily for in-house use by contractors during their design process or those developed internally by the Department of Defense are beyond the scope of this specification. 7-2