DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3 connected to a computer, users can send SCPI commands or custom programming to control the oscilloscope through the host computer software. When the printer is con- nected, the user prints the waveform displayed on the screen through the printer. 6. LAN / UART LAN Connect the oscilloscope to the network through this interface to remotely control it. This oscilloscope complies with the LXI CORE 2011 DEVICE class instrument standard and can quickly build a test system. UART [optional] This interface connects the oscilloscope to a control system for remote control. 7.
HDMI interface [optional] You can connect the oscilloscope to a monitor with an HDMI display through this inter- face to get a larger display. Front panel functions Introduction of the main keys Level control system Vertical control system 14 Horizontal offset: Modify the horizontal displacement. When the knob is turned, the trigger point moves left and right relative to the center of the screen. During the modification, the waveforms of all channels move left and right, and the horizontal displace- ment information in the upper right corner of the screen changes in real time. Press this knob to quickly reset the horizontal displacement. Horizontal time base: Modify the horizontal time base.
Turn clockwise to decrease the time base and turn counterclockwise to increase the time base. During the modification, the waveforms of all channels are expanded or compressed, and the time base information at the top of the screen changes in real time. Press this knob to quickly switch between single and double window display modes.