DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3 Signal source Note: This function is only applicable to digital oscilloscopes with signal source chan- nels. Trigger control 15 Analog input channel switch. Press any button to open the corresponding channel menu, and press again to close the channel. Math: Press the "Math" button to open the Math setup menu, and press again to close the Math function. Vertical offset: Modify the vertical shift of the current channel waveform. Turn clockwise to increase displacement, turn counterclockwise to decrease displacement.
Dur- ing the modification, the waveform will move up and down, and the displace- ment information displayed at the top right of the screen will change in real time. Press this knob to quickly zero the vertical displacement. Vertical voltage: Modify the vertical scale of the current channel. Turn clockwise to decrease gears and turn counterclockwise to increase gears. During the modification, the waveform display amplitude will increase or decrease, and the gear infor- mation at the bottom left of the screen will change in real time. Press this knob to quickly switch the vertical scale adjustment mode to "Coarse" or "Fine". WaveGen:
Press this key to enter the setting interface of the signal source. Set the waveform and parameters of the output signal from the signal source.