DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3 Automatic waveform display Operational control Single trigger Multifunction knob 16 Trigger level: Modify the trigger level. Turn clockwise to increase the level, and turn counterclock- wise to decrease the level. During the modification, the trigger level line moves up and down, and at the same time, the value in the trigger level message box at the top right of the screen changes in real time. Press this knob to quickly restore the trigger level to the zero point of the trigger data source. TrigMenu: Press this key to open the trigger operation menu.
This oscilloscope provides a varie- ty of trigger types, please refer to the detailed introduction in "Trigger System". ForceTrig: A short press of this key will force a trigger signal. Press and hold this key to open the history waveform. AutoScale: Press this key to enable the automatic waveform setting function. The oscilloscope will automatically adjust the vertical scale, horizontal time base, and trigger mode according to the input signal to achieve the best waveform display. Run/Stop: Press this key to "run" or "stop" waveform sampling. In the Run state, the green backlight of the key is on; in the Stop state, the red backlight of the key is on. Single:
Press this key to set the trigger mode of the oscilloscope to “Single”. In single trigger mode, press the “Force Trig” key to immediately generate a trigger signal. V0： The multi-function knob can perform various settings, such as adjusting the wave- form brightness, trigger time, selecting the trigger type, selecting the trigger source, the signal source waveform, frequency, offset, amplitude, etc.; the multi-function indi-