2 Functions of Devices in DVP-PLC 3. The function: All output frequency and number of pulses stated in the table above can be modified when M1133 = On and M1135 = On. The modification will not affect the present output pulses. The present number of output pulses is updated in every scan time. When M1133 turns from “Off” to “on”, the nu mber will be cleared as “0”. When 1133 tu rns from “On” to “Off”, the last number of output pulses will be shown. Note: The special high-speed pulse output function can only be used on specific Y0 output point when PLC is in RUN status. It can coexist with PLSY (Y0) in the program and PLSY (Y1) will not be affected.
If PLSY (Y0) instruction is executed prior to this function, the function cannot be used and vice versa. When the function is executed, the general function, general Y0 output will be invalid but Y1 ~ Y7 can be used. T he output frequency of this function is higher (max. 50kHz) than that of PLSY instruction. Function 2-axis Synchronous Control (PH) Group Number M1133, M1135, D1133 ~ D1136 Contents: 1. S cial M for 2-axis synchronous drawing d arc for SC_V1.4 and versions above: pecial D and spe oblique an 2. Par 133, D1135:
ameters for D1 DVP-PLC Application Manual 2-94 Index Function + 4 The lower 16 bits of the 32 bits of the present number of special high-speed pulses Y0 + 5 The higher 16 bits of the 32 bits of the present number of special high-speed pulses Y0 Device No. Function M1133 Start flag for Y10 output for two-axis synchronous control M1135 Start flag for Y11 output for two-axis synchronous control D1133 Start No. of control register (D) for Y10 output for two-axis synchronous control D1134 Number of sections for Y10 output for two-axis synchronous control D1135 Start No.
of control register (D) for Y11 output for two-axis synchronous control D1136 Number of sections for Y11 output for two-axis synchronous control Index Function + 0 Y10, Y11 2-axis synchronous control; output frequency of 1st section = low 16 bits of 32 bits + 1 Y10, Y11 2-axis synchronous control; output frequency of 1st section = high 16 bits of 32 bits + 2 Y10, Y11 2-axis synchronous control; output pulse number of 1st section = low 16 bits of 32 bits + 3 Y10, Y11 2-axis synchronous control; output pulse number of 1st section = high 16 bits of 32 bits