DVS-108 Series Managed Industrial Ethernet Switches User Manual 3.1.3.2 LAG Settings You can configure LAG settings and monitor LAG status in this page. 3-10 Description Factory Default Physical Mode Specify the port to auto-negotiation, or a specific speed and duplex mode for the interface: Auto: The duplex mode and speed of the interface are set by the auto-negotiation process. The interface can support the maximum capability: Full duplex and 1 Gbps or 100Mbps. 10 Mbps Half Duplex: Indicates the interface works at 10 Mbps in the half duplex mode. 10 Mbps Full Duplex: Indicates the interface works at 10 Mbps in the full duplex mode. 100 Mbps Half Duplex:
Indicates the interface works at 100 Mbps in the half duplex mode. 100 Mbps Full Duplex: Indicates the interface works at 100 Mbps in the full duplex mode. Note: If you need to insert the 100FX transceiver to SFP port, please indicate the interface works at 100 Mbps in the full duplex mode. Auto Physical Status This field displays the actual port speed and duplex mode. None Flow Control Mode This field displays whether flow control is enabled for the port: Enable: Flow control is enabled. If the port buffers become full, the switch sends pause packets. Disable: Flow control is disabled. If the port buffers become full, the switch does not send pause packets.
Disable Jumbo Frame The field displays whether jumbo frame is enabled for the port. Enable: Jumbo frame is enabled. The switch supports a fixed jumbo frame size - 9000 bytes payload (9218 bytes frame) size. Disable: Jumbo frame is disabled. Disable Link Trap Specify whether to send a trap when the interface link status changes: Enable: When the link status changes, the switch sends a trap. This is the default setting. Disable: When the link status changes, the switch does not send a trap. Enable