50 6 Click ” Configurations and Setup ”->”Controller Setup” ->”Built-in EtherNet/IP Setting” to check the IP address in TCP/IP Settings. IP address is set to “192.168.250.1” here. 7 Click ”Project ”->”Build Controller” or press down the “F8” key to execute build and make sure that build ends normally. If a build error occurs, correct the project by following the message displayed in the Build Tab Page, and executes build again. 8 Connect the NJ online with PC. Select “Synchronization” and click the “Transfer to Controller” button to transfer the project to the NJ. After the transfer, make sure that no error exists in the NJ. 9 Open the project of the NA.
Select ” HMI NA5 0” from the _ _ pull-down menu of Multiview Explorer. 10 Click” Configurations and Setup”->”HMI Settings” to check the IP address in TCP/IP Settings. IP address is set to ”192.168.250.2” here.