Kendrion Kuhnke Automation GmbH Hardware 4.1.2 Mounting Kuhnke's FIO modules are intended for mounting rail installation (DIN EN 50022, 35 x 7.5 mm). 4.1.2.1 To snap on a single module 1. Push up the module against the mounting rail from below, 2 allowing the metal spring to snap in between mounting rail and mounting area as illustrated. 2. Push the top of the module against the mounting wall until it snaps in. Figure 5: Rail mounting of module 4.1.2.2 To interconnect two modules 1 After snapping on the first module to the rail, snap on the second module about 1cm away towards the right of the first module.
Push the second module along the rail towards the first module until you hear the locking device snap in. 4.1.2.3 To disconnect two modules Push down the unlock button (see Figure7) of the module that you wish to disconnect from the module to the left of it. Push both module away from one another until they are about 1 cm apart. 4.1.2.4 To take down a single module 1. Push the module up and against the metal spring located on the underside of the rail guide. 2. Tip the module away from the rail as shown in the illustration. 3. Pull the module down and out of the mounting rail. 2 3 Unlock button Figure6: Uninstalling a module 1 Kuhnke FIO CAM Control ( E 808 GB ) 16 11/10/2017