EWM1000 1.4 Phases of the diagnostics test After accessing the diagnostics cycle, and irrespective of the type of control board fitted to the appliance (i.e. vertical or horizontal buttons) and the configuration of the selector, turn the programme selector clockwise to perform the diagnostics cycle for the various components and to read the alarms. All the alarms are enabled during the diagnostics cycle. (*) In most cases, this time is sufficient to check the heating function. However, the time can be increased by repeating the heating phase without draining the water:
pass for a moment to a different phase of the diagnostics cycle and then back to the heating check phase (if the temperature is higher than 80°C, heating does not take place).
QUICK GUIDE AND APPLIANCES LIST 6/176 599 72 40-80 Position of selector Components activated Conditions of operation Function tested 1 - All the LEDs light in sequence - When a button is pressed, the corresponding LED lights (and the buzzer may sound) Always enabled Operation of the user interface 2 - Door safety interlock - Washing solenoid valve Door locked Water level lower than anti- overflow level Maximum time 5 minutes Water ducted through washing compartment 3 - Door safety interlock - Pre-wash solenoid valve Door locked Water level lower than anti- overflow level Maximum time 5 minutes Water ducted through pre-wash (bleach) compartment 4 - Door safety interlock - Washing and pre-wash solenoid valves Door locked Water level lower than anti- overflow level Maximum time 5 minutes Water ducted through conditioner compartment 6 - Door safety interlock - Wash solenoid (if the water in the tub is below 1st level) - Heating element Door locked Water level > 1st level Maximum time 10 minutes or up to 90°C (*) Heating 7 - Door safety interlock - Wash solenoid (if the water in the tub is below 1st level) - Motor (55 rpm clockwise, 55 rpm anti-clockwise, impulse at 250 rpm) Door locked Water level > 1st level Check for leaks from the tub 8 - Door safety interlock - Drain pump - Motor up to 650 rpm then at maximum spin speed Door locked Water level lower then anti- boiling level for spinning Drain and spin, check for congruence in closure of pressure switch levels 9 Only for top-loaders with drum positioning system:
- Door safety interlock - Motor (25 rpm) - Drain pump Door locked Water level lower then anti- boiling level Maximum time 2 minutes Test for positioning of drum