PROGRAMME SELECTION - Press the ON/OFF key ( SW0 ) to switch the appliance on. - LED L a will light (fixed, not flashing). - The SALT LED ( L s ) may light. - Press the one of the PROGRAMME keys ( SW1 - SW 5) to select the desired washing cycle. - The corresponding PROGRAMME LED ( L 1 - L 5) ) flashes normally ( F_N ) to confirm selection. - Each time a key is pressed, the buzzer emits a short signal (Sequence_ A ) to confirm correct selection. - The appliance will remain in PROGRAMME SELECTION mode until the door is closed; the settings selected can be altered. PROGRAMME EXECUTION After checking that the programme setting is correct, proceed as follows:
- Close the door - A short buzz (Sequence_ B ) sounds to confirm that the washing cycle has started. - The corresponding PROGRAMME LED ( L 1 - L 5 ) lights continuously to confirm that the cycle selected is now in execution. - At this point, the cycle selected can no longer be modified; it may only be annulled or cancelled. N.B. If the ON/OFF key is pressed, the cycle is interrupted but not cancelled. END OF PROGRAMME - The buzzer sounds intermittently (Sequence_ C ) to signal the end of the washing cycle. - When the door is opened: - The END OF CYCLE LED ( L f ) lights (flashing_ F N ) - The ON/OFF LED ( L a ) lights. - The SALT LED ( L s ) may also light.
- The PROGRAMME LEDs ( L 1 - L 5 ) switch off. N.B. If the END OF CYCLE LED ( L f ) is switched off, this means that the cycle is still being performed; in this case, either close the door to complete the cycle or cancel the cycle. •) - Press the ON/OFF key ( SW0 ) to switch the appliance off. CANCELLING A PROGRAMME The cycle can be cancelled after it has been started as follows: - Open the door. - Press and hold down (for 1 second) the PROGRAMME key ( SW1 - SW5 ) for which the corresponding LED ( L1 - L5 ) is lit. The LED will switch off. - The appliance returns to PROGRAMME SELECTION mode, and the user can now select a new washing cycle. 10