"BUZZER" - The piezoelectric buzzer is mounted on the control board. - The buzzer sounds to indicate the beginning and the end of the cycle, and also when one of the keys is pressed (to confirm correct actioning). operation of the buzzer: Sequence_ A (when a key is pressed): Sounds for 80 ms. Sequence_ B (start of cycle): Sounds for 500 ms. Sequence_ C (end of cycle): Sounds intermittently for 5 seconds (500 ms on, 500 ms off). If it is preferred to exclude the buzzer, this option can be selected either in the PROGRAMME SELECTION phase or in the CYCLE EXECUTION phase as described below: ACTIVATING AND DISACTIVATING THE BUZZER With the door open and the DW switched on :
EXCLUDE BUZZER - Press SW3 and SW4 at the same time, and hold both keys down for three seconds ; the buzzer will sound (sequence_ C ) for three seconds , after which it will be disabled. RESET BUZZER - Press SW3 and SW4 at the same time, and hold both keys down for three seconds ; after the three seconds have elapsed, the buzzer will sound (sequence_ C ) to indicate that the buzzer is again enabled. 9