1 Purpose of this manual The purpose of this manual is to provide service engineers who are already familiar with the repair procedures for traditional washing machines with information regarding appliances fitted with the ENV06 electronic control system and produced in Porcia (Italy) and Olawa (Poland). The characteristic of the ENV06 electronic control system is to use only an electronic pressure switch to check the various water levels in the tub (with the elimination of the mechanical pressure switches: anti-overflow, anti- boiling, 1st-2nd level), and a new heater with two thermal fuses which interrupt if the temperature degree overcomes the values by which they are calibrated.
The following are described: general characteristics control panel and washing programmes technical and functional characteristics access to the electronic control system For detailed information concerning hydraulic circuit, structural characteristics of the appliances and accessibility, please refer to Service Manual : Publication no. 599 37 67-82 – washing machines with HEC-ARCHED cabinet. Identification table between styling (SERIES 6 / 7) and functionality (EWM 21xx/25xx) 2 PRECAUTIONS ѓ Electrical appliances must be serviced only by qualified Service Engineers. ѓ Always remove the plug from the power socket before touching internal components.
ѓ In case of replacement of the heater, replace it with one with the same characteristics in order not to compromise the safety of the appliance. SOI/DT 2007-11 dmm 5/69 599 70 39-88 Styling EWM 21xx EWM 25xx Washing type Motor Washing type Motor SERIES 6 • Traditional with ECO-BALL • Jet-System Universal • Traditional with ECO-BALL • Jet-System Three-phase asynchronous with Inverter SERIES 7 -------------------------- ----------- • Traditional with ECO-BALL • Jet-System Three-phase asynchronous with Inverter