3 SERIES 6 3.1 GENERAL CHARACTERISTICS The ENV060 electronic control system consists of a single PCB, which incorporates the power, control and display (where the LCD is connected) functions. The programme selector is incorporated in the board. The PCB is mounted on a casing fitted to the control panel. 3.1.1 General characteristics WM SOI/DT 2007-11 dmm 6/69 599 70 39-88 Version SERIES 6 Version SERIES 6 Special Number of buttons Max. 7 (6 options + start/pause) Number of LEDs Max.
12 + LCD Programme selector 21 positions with main switch (incorporated in the PCB ) Serial port DAAS-EAP communications protocol up to 115.200 baud Power supply 220/240V 50/60 Hz (configurable) Type of washing Traditional with “eco-ball” sphere Jet-system Rinsing system Traditional with “eco-ball” sphere Jet-system Motor Collector, with tachometric generator Two-pole asynchronous, with three-phase tachometric generator (with Inverter) Spin speed 1000 ÷ 1600 rpm Anti-unbalancing system FUCS Water fill 1 solenoid valve with 1 inlet – 2/3 outlets Detergent drawer 3/4 compartments:
prewash/stains, wash, conditioners Control of water level in the tub Electronic/analogue pressure switch Door safety device Traditional (with PTC) Instantaneous Power of heating element 1950W with thermal fuses incorporated Temperature control NTC sensor incorporated in the heater Buzzer Traditional incorporated in the electronic board Sensors Water fill gauge (flowmeter) Aqua control