User Manual EM303B General Purpose Inverter If auxiliary speed + primary speed > the upper limit frequency, inverter will output as per the upper limit frequency. F9-03 ones place =1/2 can be switched to the status of F9-03 tens place =0 through multi-function terminal. F9-03 tens place is for speed setting mode when jog control mode is enabled. F9-03 tens place=0 If jog command is enabled, speed setting value=F0-11 Jog numeric frequency. F9-03 tens place=1 If jog command is enabled, speed setting value=F0-11 Jog numeric frequency+ Primary speed setting.
F9-03 tens place=2 If jog command is enabled, speed setting value=F0-11 Jog numeric frequency+ auxiliary speed setting (Please pay attention to that the value is positive or negative). F9-03 tens place=1/2can be switched to the status of F9-03 hundreds place =0 through multi-function terminal. F9-03 hundreds place is for selecting the relation between auxiliary speed and primary speed. F9-03 hundreds place=0 Primary speed + auxiliary speed F9-03 hundreds place=1 Primary speed - auxiliary speed 1. Please confirm the integrated speed setting mode first, and then confirm the primary speed setting mode and the setting method in jog control mode. 2.
Primary speed setting + auxiliary speed setting can be considered as converting those 2 signals into 0~10V voltage signal, and then take the sum of them as the integrated speed setting. If the sum>10V, it will be considered as 10V. 3. Numeric setting + analog setting can be considered as converting the analog setting into the corresponding setting frequency, and then add numeric setting frequency. Please note that if the sum is greater than the upper limit frequency, inverter will output as per the upper limit frequency. 8.11.4 Special Speed Setting Mode F9-04=0 Program Operation If F0-26 is selected as special speed setting mode, inverter will run in program setting mode.
See 7.8 for program running setting. 139 No. Function Range Unit Default Type Special Speed Setting Mode 0: Program Operation 1: Wobbulation Mode 2: Stepping Mode 0 3: Stepping Mode 1 4: Stepping Mode 2 5: Stepping Mode 3 6: Stepping Mode 4 7: Stepping Mode 5 0 〇 F9-04