User Manual EM303B General Purpose Inverter If settingFd-11 ≠ 0, the system will enter VF separation mode.After entering VF separation mode, please set F0-28=1, the parameters will be of VF separation mode. Remarks: When setting Fd-11=0 and F0-28=1, and pressing enter, the parameters will be reset to defaults. The system will exit VF separation mode. Fd-12 is for adjusting the change rate of VF separation mode. The change base is changing time of 0%~100%. 。 When Fd-11=1, FC-15 is for adjusting output voltage. 0~380V is corresponding to 0%~100%. 8.14.4 Review Inverter Parameters Parameters of Fd-21~ Fd-23are read only for the users.
Please check if the parameters are in accordance with the nameplate before inverter start-up. 8.14.5 Review and Setting Running Time of Inverter Parameters of Fd-24~ Fd-27 are read only for the users. When running timeance with the nameplate before invert would not work. If inverter runs again, it will trip fault INP (Internal Trip). Fd-28~ Fd-29are for professionals only. It is to prevent the fault caused by editing the key parameters of inverter. 8.14.6 Reviewing Software Version 157 No. Function Range Unit Default Type Fd-12 Voltage Change Time 0.00～60.00 S 5.00 ● No. Function Range Unit Default Type FC-15 Output Voltage 0.00～100.00 % 100.00 ● No.
Function Range Unit Default Type Fd-21 Inverter Rated Power 0.40~480.00 kW XXXX X Fd-22 Inverter Rated Voltage 60~660 V XXX X Fd-23 Inverter Rated Current 0.1~1500.0 A XXXX X No. Function Range Unit Default Type Fd-24 Inverter Running Time User monitoring HOUR XXXX X Fd-25 Inverter Running Time User monitoring min XXXX X Running Time Control 0:Disabled 1:Enabled 0 - Fd-26 Fd-27 Set Running Time 0～65535 HOUR 0 - No. Function Range Unit Default Type Fd-28 Distributor Password Fd-29 Manufacturer Password No. Function Range Unit Default Type Fd-20 CPUB Software Version X.XX X.XX X Fd-30 Keypad Software Version X.XX X.XX X