User Manual EM303B General Purpose Inverter Set analog input gain Ki for proportional zooming of analog signals. The setting analog value of inverter: Analog input*Analog input gain Ki （ i=1 ～ 8 ） . The description of F0-06, F5-11, F9-05 shows the correlation of 8 analog gain coefficients Ki and VP, VS, VF, IS, IF. When exceeding the setting time of F1-30, inverter will stop if it does not receive the communication command from PC/PLC. Keypad displays fault EST. It can be defined as the multi-function output terminal action of inverter fault. If the inverter is set as the master, the source of slave frequency sent by the master is chosen through F1-31. 8.3 F2 Group:
Input/output Terminal Parameters The multi-function input terminals of EM303B are also called as numeric input terminals because of working in level or pulse mode. 95 F1-24 Analog Input Gain K3 0.00~600.00 % 100.00 ● F1-25 Analog Input Gain K4 0.00~600.00 % 0.00 ● F1-26 Analog Input Gain K5 0.00~600.00 % 0.00 ● F1-27 Analog Input Gain K6 0.00~600.00 % 0.00 ● F1-28 Analog Input Gain K7 0.00~600.00 % 0.00 ● F1-29 Analog Input Gain K8 0.00~600.00 % 0.00 ● No. Function Range Unit Default Type F1-30 Communication Overtime 0.0-60.0(0.0:Disabled) S 0.0 ● No. Function Range Unit Default Type Master Communication Transmitting Data 0: Input frequency 1: Output frequency 2: Primary Numeric Frequency 3:
Auxiliary Numeric Frequency 4: VP 5: VS 6: VF 7: IS 8: IF 0 ● F1-31 No. Function Range Unit Default Type Multi-function Input Terminal X1-RUN See Table 6-1 Functions of Numeric Multi-function Input Terminals 1 〇 F2-00 Multi-function Input Terminal X2-F/R 2 〇 F2-01 Multi-function Input Terminal X3-D1 3 〇 F2-02 Multi-function Input Terminal X4-D2 4 〇 F2-03 Multi-function Input Terminal X5-D3 5 〇 F2-04