EM500 Open-Loop Vector Control Inverter User Manual 2.5 Assembly and Disassembly of Keypad Generally it’s not necessary to disassemble keypad while using an inverter. If necessary, observe the following methods to disassemble or install keypad. The keypad cover should be used for inverter 22kW and above if the keypad is disassembled Disassemble keypad: Put your fingers in finger slots on the top of keypad, press down keypad slightly and pull it outward (see Figure 2–3). For more than 22 kw inverter, after dismantling the keyboard, also need to use the attached cap to cover the hole. Step 1: Step 2: 拆掉面板上两颗 Remove two M4 set screws on the face panel and push the face panel downward.
拆掉键盘安装 板上两颗 M4 固定螺钉，然 后将键盘安装 板向上推。 M4 固定螺钉，然 后将面板向下推 。 Remove two M4 set screws on the keypad and push the keypad installation panel upward. Step 3: Step 4: Figure 2-3 Disassemble Keypad 30