EM500 Open-Loop Vector Control Inverter User Manual 6. Function Code Table 6.1 Parameter Description EM500 inverter has 24 groups of function codes as shown in Table 6–1, each group having multiple function codes. F18 is a monitoring parameter group and used for viewing inverter status; F19 is a fault record group and used for viewing three latest faults; other groups are parameter setting groups and used for setting different functions. Table 6–1 Introduction of Parameters ★ Note: If some parameters of EM500 are not used, 0 is returned after read; if user retains some options of some parameters, these options can be set, but may result in abnormal running of inverter.
Please prevent incorrect operation of these parameters. The table below describes all items of the function code table:
74 F00 Basic Function Parameter Group F01 Motor 1 Parameter F02 Input Terminal Function Group F03 Output Terminal Function Group F04 Start/Stop Control Parameter Group F05 V/F Control Parameter Group F06 Vector Control Parameter Group F07 Protection Function Setting Group F08 Preset Speed and Simple PLC F09 PID Function Group F10 Communication Function Group F11 User-Defined Parameter Group F12 Keypad and Display Function Group F13 Torque Control Parameter Group F14 Motor 2 Parameter Group F15 Auxiliary Function Group F16 Customized Function Group F17 Virtual I/O Function Group F18 Monitoring Parameter Group F19 Fault Record Group F25 Application of water supply basic groups F26 Application of water supply advanced group F27 Winding Applications Parameter Group F28 Air compressor Applications Parameter Group No.
F00.00 - F99.99: Numbering of function codes Complete names of function codes. “Not Used” means that this function code will be retained temporarily, without actual meaning. Function Brief Parameter Description. Range The value of the whole function code represents present parameter selection or meaning. Overall