EM600 High-Performance Vector Control Inverter User Manual Press ENTER under user-defined mode to enter the second level menu, which only displays 32 user-defined codes of F11. Select codes among these 32 function codes according to user needs; for those functions codes that need to be changed or viewed frequently, user can complete settings by entering F11 group under the all menu mode. After the codes are defined in F11, we select and enter user-defined mode again and we can see that the first function code is F00.07 defined by F11.00 and the second function code is F00.09 defined by F11.01 until F11.31. There are 32 function codes.
Only 32 function parameters can be displayed by entering this mode. Changing function parameters under the third level menu has the same effect as that under the all menu mode with the same methods. See Figure 4–6. ESC ENTER ENTER >> Flashing bit 闪烁位 ESC ENTER Figure 4-6 Changing Function Code under User-Defined Mode Press in the second level menu under user-defined mode to switch to parameters set by previous or next user, because user can not add or remove any function parameter of the second level menu. Switch sequence: from function parameter defined by F11.00 to function parameter defined by F11.31. Press >> in the second level menu and cursor will not shift.
After entering the third level menu by pressing or ENTER , the lowest position of cursor will flash if current status of corresponding function code is permitted for change. The method of changing parameters is the same as that in the third level menu under all menu mode; after changing, press ENTER to save the change and enter next user-defined parameter. Changing parameter in the third level menu under different menu modes has the same effect. 4.2.3 Non-factory defaults (--C--) Press ENTER under this mode to enter the second level menu, which displays the first parameter that starts from F00.00 and differs from default setting of inverter.
No shifting works by pressing >> under this mode; no function group or function parameter can be changed arbitrarily by pressing , but one previous/next non-factory default of function code will be displayed accordingly. The lowest position of cursor will flash if current function code is permitted for change. The method of changing parameters is the same as that in the third level menu under all menu mode; after changing, press or ENTER to save the change and enter next non-factory default parameter.
For instance, if we set F00.03 as 1 and set F00.07 as 40.00 under the all menu mode, which are not factory defaults, then when entering the non-factory defaults mode, the first 50 Fla闪shin烁g bit 闪Fla烁shin位g bit