EM600 High-Performance Vector Control Inverter User Manual Under all menu modes, press ENTER to save parameter change after having changed parameter. The difference is that after having saved the parameter: it enters next function code under all menu mode; it enters next user-defined function code (as per sequence in F11.00 - F11.31) under user-defined mode; it enters next non-factory function code under non-factory defaults mode.
Press ESC to cancel parameter change under the third level menu; If function code is changed to a value as it is, it will exit the third level menu and get back to second level menu; before completing the change, press ESC to cancel the change with the original parameter value displayed, and press ESC again to exit the third level menu and return to the second level menu. See Figure 4–4 for details.
ENTER Flashing bit 闪烁位 ESC 闪烁位 Flashing bit ENTER >> Flashing bit 闪烁位 Flashing bit 闪烁位 ESC ESC Flashing bit Figure 4-4 Procedure of Cancelling Parameter Change by Pressing ESC Flashing bit 闪烁位 闪烁位 ENTER 4.2.2 User-Defined Mode (--U--) When entering function code group F11 from the all menu mode, the third level menu still displays function codes, which can be set as you please.
Default display is U00.00 for the first time to enter F11.00, which means that default function code of F11.00 is F00.00; at this time, the lowest cursor bit flickers and user can set any function parameter as in selecting a function code in the second level menu; press ENTER to save setting; when entering the user-defined mode, only corresponding function parameters will be shown. For instance, we set F11.00 as U00.07 and set F11.01 as U00.09, i.e., F11.00 and F11.01 are respectively defined as F00.07 and F00.09. Letters U and F are used for distinguishing. U means that the function parameter is user defined. See Figure 4–5 for details.
ESC ENTER >> ESC ESC >> 闪烁位 ESC ENTER 闪烁位 Flashing bit Flashing bit Flashing bit Flashing bit 闪烁位 ENTER 闪烁位 ENTER 闪烁位 Flashing bit Flashing bit ESC 闪烁位 Flashing bit Flashing bit 闪烁位 闪烁位 ENTER Figure 4-5 Example of User-Defined Mode Setting 49