User Manual of EM730/EM730E Series Inverter F02.32 is used to select the corresponding offset curve for each analog input terminal. In total, four groups of offset curves are available. Among them, the curves 1 and 2 indicate two-point offsets, while the curves 3 and 4 indicate four-point offsets. After selecting an offset curve, you can set the corresponding function code to meet the input requirements. The filtering time can be adjusted according to the analog input and actual working conditions. The actual effect will prevail.
This function code can be increased properly in the case of analog input hysteresis, long 164 F02.42 Minimum input setting of curve 3 –100.0 - +100.0 % 0.0 ● F02.43 Input of inflection point 1 of curve 3 F02.41 - F02.45 V 2.50 ● F02.44 Input setting of inflection point 1 of curve 3 –100.0 - +100.0 % 25.0 ● F02.45 Input of inflection point 2 of curve 3 F02.43 - F02.47 V 7.50 ● F02.46 Input setting of inflection point 2 of curve 3 –100.0 - +100.0 % 75.0 ● F02.47 Maximum input of curve 3 F02.45 - 10.00 V 9.90 ● F02.48 Maximum input setting of curve 3 –100.0 - +100.0 % 100.0 ● F02.49 Minimum input of curve 4 -10.00 - F02.51 V 0.10 ● F02.50 Minimum input setting of curve 4 –100.0 - +100.0 % 0.0 ● F02.51 Input of inflection point 1 of curve 4 F02.49 - F02.53 V 2.50 ● F02.52 Input setting of inflection point 1 of curve 4 –100.0 - +100.0 % 25 ● F02.53 Input of inflection point 2 of curve 4 F02.51 - F02.55 V 7.50 ● F02.54 Input setting of inflection point 2 of curve 4 –100.0 - +100.0 % 75 ● F02.55 Maximum input of curve 4 F02.53 - 10.00 V 8.80 ● F02.56 Maximum input setting of curve 4 –100.0 - +100.0 % 100 ● F02.57 AI1 filtering time 0.00 - 10.00 s 0.10 ● F02.58 AI2 filtering time 0.00 - 10.00 s 0.10 ● Function Default Function code name Parameter description Unit Attribute code setting F02.61 AD sampling hysteresis 2 - 50 2 〇