User Manual of EM730/EM730E Series Inverter code F11.01, and so on to F11.31, 32 in total. Function code modification in the Level 3 menu is equivalent to that in the full menu mode, and the modification method is also the same. on the keyboard, to change the function code defined by F11.00 to that defined by F11.31. In the Level 2 menu of the user-defined mode, turn the potentiometer key Press the ENTER key When the right shift key to enter the Level 3 menu. If the displayed function code is is pressed in the Level 2 menu, the cursor will not shift. modifiable currently, the lowest bit indicated by the cursor will flicker.
Parameter modification is the same as that in the Level 3 menu under the full menu mode. After modification, press the ENTER key ENTER to confirm and save the parameters and enable next user-defined parameter. Function code modifications in the Level 3 menus under different menu modes have equivalent effects. 4.2.3 Non-default mode ( -- C -- ) In the non-default mode, press the ENTER key to enter the Level 2 menu. The first parameter different from the default settings of the inverter will be displayed, starting from F00.00. When the right shift key is pressed in the Level 2 menu, the cursor will not shift.
If the increment or decrement key on the keyboard is pressed, the function group and function code will not be modified, and the non-default function code following and in front of the current function code will be displayed respectively. If the displayed function code is modifiable currently in the Level 3 menu, the lowest bit indicated by the cursor will flicker. In this case, parameters can be modified in the Level 3 menu under the full menu mode. After modification, press the ENTER key to confirm and save the parameters and enable next non-default parameter. default values. Then enable the non-default mode. F00.03 will be displayed first.
When the For example, change F00.03 to 1 and F00.07 to 40.00 in the full menu mode, which are not potentiometer key on the keyboard is turned clockwise, F00.07 will be displayed; and when the potentiometer key on the keyboard is turned counterclockwise, F00.03 will be returned, as shown below: 53