The independent chuck The clamping plate 90 mm diameter For clamping round, square, rectangular uneven shaped workpieces. Each jaw can be adjusted individually. Workpieces can be clamped centrically excentrically. and Clamping capacity using the small up to 13 mm (1/2"). and Clamping capacity using the big T-nut screws: to 33 mm (1/3"). T-nut screws: up Mounting Mount the independent chuck to the spindle nose with the 4 screws (M5x25, DIN 912). Often uneven or irregular shaped workpieces canna. be clamped with the 3-jaw chuck or the 4jaw independent chuck.
Spindle nose Using PER LP 1 0.04) 42 21 86 16% | O8F } 34% | ng 9 43° | 0355] and the clamping shoes, Mount the clamping plate onto the spindle nose rs 13 Je) screws with the 4 socket head screws M5x20. ay yt) dg min, | dy max. | dx min. | da max. | dg Max. | dip MIN. | das MIN, T-nut Mounting Clamping capacities MOREE the uneven or large-dimensioned workpieces can be clamped. The rings turned into the clamping plate serve as an aid for centrical clamping. Threaded bores for independent chuck fdyp Max.}de4 max. 2 90 10 1L15*} 354t] 43" Uneven workpieces often cause unbalanced round-run. Therefore always work with low spindle speeds. Be careful of extending parts. 18