Command List of the Alphabetical Order 1 "Priority" indicates the function is executed with priority. ESC/Label Command List Rev. C SHEET26 CW-C4000 series Command Function identifier Command name Description Classification Command code Description of parameters Definition range for ESC/Label Definition range Factory-set initial value Corresponding ZPL II command Priority 1 ^S(C MP Set print operation mode Sets print operations (print operation mode, basic printer unit system, or printing direction). Printer setting ^S(CMP,b,c b=M: Print operation mode c=T/P/R/A/C/D/F/L/U/K T: No cutting P: Manual peeling and application R: Rewind A: Automatic peeling and application C:
Cutting performed D/F/L/U/K: Reserved c=C/P/R/T C: Cutting performed P: Manual peeling and application R: Rewind T: No cutting T ^MM Low b=U: Basic printer unit system c = D/I/M D: Dots I: Inches M: Millimeters c = D/I/M D: Dots I: Inches M: Millimeters D ^MU b=D: Printing direction c = B/U B: Bidirectional or Unidirectional U: Unidirectional c = B/U B: Bidirectional or Unidirectional U: Unidirectional B ^S(C MS Set printing control adjustment amount Sets printing control adjustment amount. Printer setting ^S(CMS,b,c b=C: Wait time adjustment for closing caps [sec] 0.0 ≤ c ≤ 60.0 1.0 ≤ c ≤ 15.0 3.0 Low b=H:
Drying time per head pass [sec] 0.0 ≤ c ≤ 60.0 0.0 ≤ c ≤ 5.0 0 ^S(C MT Set auto cleaning on designated time Sets auto cleaning on designated time (auto cleaning on designated time or time to start auto cleaning). Printer setting ^S(CMT,b,c b=T: Time to start auto cleaning hh:mm hh & mm are number within two digits hh = 00 to 23 mm = 00 to 59 hh:mm hh & mm are number within two digits hh = 00 to 23 mm = 00 to 59 If a time within 10 minutes of the current time is specified, cleaning is performed starting at the given time 24 hours later.
00:00 Low ^S(C MV Set nozzle self-test operation Sets nozzle self-test operations ( cleaning after self-test, permitted clogged nozzle number, self-test interval in printing (number of labels), operation at clogged nozzle detection, or enable/disable nozzle self- test). Printer setting ^S(CMV,b,c b=A: Cleaning after self-test c = N/E N: None E: Automatic execution c = N/E N: None E: Automatic execution E Low b=C: Permitted clogged nozzle 0 ≤ c ≤ 9999 0 ≤ c ≤ 16 2 number b=I: Self-test interval in printing (number of labels) 0 ≤ c ≤ 99999999 0: Job separator only 1 ≤ c ≤ 9999 100 b=O: Operation at clogged nozzle detection c = C/N C: Continue printing N: Notify c = C/N C: Continue printing N:
Notify C b=S: Enable/disable nozzle self-test c = E/D E: Enabled D: Disabled c = E/D E: Enabled D: Disabled E