[Encoding] Numerals (0 to 9) can be encoded. 10 characters can be encoded. A zero is added automatically as the number system character. The check digit is added automatically. The check digit is calculated by modulus 10 / 3 weight for the 10-character string after compression. The specified 10-character field data is compression into 6 bytes of data. a) Only when the 10-character field data matches any of Case 1 to 6 in the following table is it handled as valid field data. The 10-character field data is expressed as d1 to d10. b) Data is compressed into 6 bytes data according to Cases 1 to 6, as matched in a) above. The 6 bytes data is expressed as D1 to D6.
[Response] None [Reference] Related commands: ^FW , ^BY ESC/Label Command Reference Guide Rev. L Page 60 Case d1 d2 d3 d4 d5 d6 d7 d8 d9 d10 1 0 to 9 0 to 9 0 0 0 0 0 0 to 9 0 to 9 0 to 9 2 0 to 9 0 to 9 1 0 0 0 0 0 to 9 0 to 9 0 to 9 3 0 to 9 0 to 9 2 0 0 0 0 0 to 9 0 to 9 0 to 9 4 0 to 9 0 to 9 3 to 9 0 0 0 0 0 0 to 9 0 to 9 5 0 to 9 0 to 9 0 to 9 1 to 9 0 0 0 0 0 0 to 9 6 0 to 9 0 to 9 0 to 9 0 to 9 1 to 9 0 0 0 0 5 to 9 Case D1 D2 D3 D4 D5 D6 1 d2 d3 d9 d10 d11 0 2 d2 d3 d9 d10 d11 1 3 d2 d3 d9 d10 d11 2 4 d2 d3 d4 d10 d11 3 5 d2 d3 d4 d5 d11 4 6 d2 d3 d4 d5 d6 d11