The continuous label layout is shown below. Figure 4.3.2-3 Continuous label layout Table 4.3.2-3 List of continuous label setting values For black mark detection, the command can be set with the value obtained by subtracting the gap between labels from the gap between black marks as the length, using the gap between black marks and gap between labels as user input. Long format printing is possible with a no-mark layout. Refer to "Chapter 5.4 Long format printing" for more information about the long format printing method. Epson ESC/Label Application Development Guide CW-C4000 Series Rev.
C Page 22 Item Setting range Recommended initial value Command Width [mm] 21.4 to 108.0 108.0 ^S(CLS,P Length [mm] 8.0 to 406.4 174.8 ^S(CLS,L Gap between labels [mm] 0.0 to 6.0 0.0 ^S(CLS,C Left gap [mm] 2.0 2.0 ^S(CLS,G