System Messages - Alphabetical List Find: (None) Explanation: While initiating a string search or replacement operation, the SEE editor is prompting for the string to be found in the program. User action: Enter the desired search string, or press Return to cancel the request. *First statement must be .PROGRAM* (-351) Explanation: An attempt was made to insert or deposit a program statement above the .PROGRAM statement, which must be the first statement in the program. User action: Move the cursor to below the .PROGRAM line of the program before attempting to insert or deposit statements. *Font not loaded* (-551) Explanation: The specified font does not exist. User action:
Specify another font (font #1 is always loaded). *Force protect limit exceeded* (-624) Explanation: At least one force-sensor strain gauge reading has exceeded the preset limit, causing a robot panic stop. This may happen due to high forces experienced during an insertion, a crash, or high acceleration. User action: If a crash occurred, ensure that the work area is cleared. If the limit was exceeded in normal operation, the limit should be increased or Protect mode should be disabled. Enable high power with the pendant and continue operation. *Front panel HIGH POWER lamp failure* (-924) Explanation:
HIGH POWER has been disabled because a failure (Open Circuit) in the front panel HIGH POWER lamp has been detected. The lamp is probably burned out. This condition is considered a safety hazard. An E-STOP is not signaled. However, HIGH POWER cannot be enabled until the lamp is replaced. User action: Replace the HIGH POWER lamp. See the MV Controller User's Guide . Re-enable HIGH POWER as desired. *Function already enabled* (-422) Explanation: Certain functions or operations must not be enabled when they are already enabled or active. ALTER mode is an example of such a function. User action: Avoid reenabling the function or operation.
eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 611