Follow the procedures below to connect the Vision Sensor and the robot controller and to check the connection status. 3.2.1. Verifying Ethernet Communication (FH Series Vision Sensor) 20 3.2. Connecting and Checking Vision Sensor and Robot Controller Connect the Vision Sensor and the robot controller with LAN cables. 1 (Operation of the Vision Sensor) Move the mouse cursor to lower left of the window to display [Start]. Select [Start］- [All Programs] - [Accessories] - [Command Prompt] to launch [Command Prompt]. 2 (Operation of the Vision Sensor) Execute PING command to the IP address of the robot controller.
3 (Operation of the Vision Sensor) When 32-byte data could be successfully sent/received four times as shown in the figure on the right, that means that the communications have been established and the wiring and settings of Ethernet is correctly done. 4