5.1.2 Use of a function group number for the identification of parameters 2 A parameter identification number shown on the PU can be switched from a parameter number to a function group number. 2 As parameters are grouped by function and displayed by the group, the related parameters can be set continually at a time. Changing a parameter identification number to a function group number 3 4 5 1. Turning ON the power of the inverter 6 The operation panel is in the monitor mode. 2. Selecting the parameter setting mode 7 Press to choose the parameter setting mode. 3. Selecting a parameter Press or until " " (Group parameter setting) appears. 8 Press to confirm the selection.
The setting " (initial value)" will appear. 4. Selecting the use of the function group number 9 Press or to change the set value to " " (function group number). Press to select the Group 10 parameter setting. " " and " " are displayed alternately after the setting is completed. 79 5. PARAMETERS 5.1 Parameter list Pr.MD setting Description 0 The setting of parameter identification number remains the same as the last setting. 1 The parameter number is used for the identification of parameters, and displayed in numerical order. 2 The function group number is used for the identification of parameters, and displayed in alphanumeric order. Operating procedure