Tray 4 (2000-sheet Input Tray) Adjustment Procedure This procedure applies to the 2000-sheet Input Tray (Tray 4). To adjust Trays 2 and 3 (the standard paper trays in the printer) and the 2 x 500-sheet Input Tray (Trays 4 and 5) see page 86. In some cases, the registration from the 2000-sheet Input Tray causes print to start too close to the edge of the paper. This situation is not a typical occurrence. In most cases the 2000-sheet Input Tray offset is fine. Although this may or may not be within specification, it is unacceptable to some users. Perform the following adjustment procedure to correct the situation.
1 With the 2000-sheet Input Tray stand-alone, remove left, right and rear covers from the tray. 2 Remove the vertical transfer unit. 3 Open the 2000-sheet Input Tray paper tray. 4 Loosen both screws that support the paper tray locking bracket on the right side of the 2000-sheet Input Tray (see figure 4-3). Figure 4-3 Tray 4 Position Adjustment 88 Chapter 4 Maintenance and Adjustments C4085-91087