beckhoff TF5200 — 5 Parameter

Parameter 5 Parameter Start-up parameters Other PLC parameters Value range of stop conditions Insert stop command 26 Version: 1.141 TF5200 | TwinCAT 3 CNC P-STUP-00033 Memory size for backward motion Description This parameter defines the memory size in bytes used for backward motion on the path. During start-up, the NC checks whether the required minimum size is available. If this is not the case, a warning is output and the memory size is set to the required minimum value. If the size is set to 0, the “forward/ backward motion on the path” function is not available. The maximum size is only limited by the resources available on the PC.

Parameter fb storage size[i] where i = 0 to 11 _ _ (maximum number of channels: 12, application-specific) Data type UNS32 Data range 0 ... MAX(UNS32) Dimension ---- Default value 0 Remarks Currently covered path in the NC program (PCS) Description Reads the current distance covered in the NC program since program start or since the last # DISTANCE PROG START CLEAR NC command. The calculation is based on the current position in the current NC block. Signal flow CNC → PLC ST path gpCh[channel idx]^.bahn state.dist prog start _ _ _ _ Data type UDINT (* LREAL) Unit 0.1 µm Access PLC is reading Special features * As of CNC Build V3.1.3104.01 the data element is provided in LREAL forma.

Stop condition Description Displays the condition why the current motion was stopped. Signal flow CNC → PLC ST path gpCh[channel idx]^.bahn state.stop conditions r _ _ _ _ Data type DINT Value range See Value range of stop conditions [} 26] with explanations. Access PLC is reading Constant in PLC Value Explanation HLI SC FEEDHOLD _ _ 0x0001 Path feed stop HLI SC VFG _ _ 0x0002 No axis-specific feed enable. HLI SC SINGLE BLOCK _ _ _ 0x0004 Single step mode active. HLI SC M00 OR M01 _ _ _ _ 0x0010 M00 (programmed stop), M01 (optional stop) is active. HLI SC PLC ACKNOWLEDGE _ _ _ 0x0020 Stop occurs due to waiting for an acknowledgement from the SPS.

This may occur as a result of the output of M or H technology functions but is not restricted to them alone. HLI SC OVERRIDE ZERO _ _ _ 0x0040 Override = 0.