I NSTALLING YOUR REFRIGERATOR These instructions were provided to aid you in the installation of your refrigerator. The manufacturer cannot be responsible for improper installation. How to remove wooden base Steps to follow… CAUTION To avoid personal injury or property damage, two people must remove wooden base. A qualified engineer must connect refrigerator in accordance with these installation instructions. Measure door opening and depth and width of refrigerator. Remove handles or doors if required. Engineer must also do the following: 1. Tape doors shut to prevent doors from opening unexpectedly. 2. Slide appliance cart under side of refrigerator. 1.
Follow local water and electrical company connection regulations. 3. Wrap refrigerator with blanket or pad. Thread strap around refrigerator. Put foam shipping pads, located in shipping carton, under strap. Tighten strap securely. 2. Complete water supply connection before electrical supply connection. Service to or replacement of power cord must be performed by a qualified servicer. 4. Lower appliance cart to floor with appliance cart handles on bottom. 5. Remove top two bolts from skid. 1. Install on an earthed outlet with a separate 220-240 volt, 50hz., 10A circuit. 6. Return refrigerator and appliance cart to an upright position. Remove strap. 2.
Protect soft flooring with cardboard or rugs. 7. Slide appliance cart under opposite side of refrigerator. 3. Provide 5 mm clearance at side of refrigerator and for models more than 60 cm deep, provide 12.7 mm clearance at top and back of refrigerator. 8. Repeat steps 3–5. 9. Remove wooden base. 10. Return refrigerator and appliance cart to an upright position and remove appliance cart. 4. 60 cm deep models. Trim corners of counter top to a 45° angle if counter top has 25 mm overhang. IMPORTANT: Do not leave refrigerator on its side longer than necessary to remove bolts. 3