How to level your refrigerator TOOLS NEEDED: FOR PULLOUT DRAWER ONLY: 3 8 " hex head driver Level 1. Turn both stabilizing legs clockwise until firmly against floor. Turn roller adjustment screws 2 to 3 times counterclockwise so that the full weight of refrigerator rests on stabilizing legs. To avoid damage to walls and flooring, protect soft vinyl or other flooring with cardboard, rugs or other protective material. 1. R e m o v e toe grille and bottom hinge covers. CAUTION 2. Turn both front adjustment screws (A) clockwise to raise and counterclockwise to lower. Roller Adjustment Screw To avoid damage or breakage to adjusting bolt, do not use power tools to correct leveling.
Stabilizing Leg DO NOT adjust refrigerator down to where the base of the refrigerator which supports the condenser is resting on the floor. Doing so may damage underside components. 2. Replace toe grille and bracket cover(s). See markings on inside of toe grille to insure proper placement. A 3. Turn both rear adjustment screws (B) clockwise to raise and counterclock- wise to lower. Snap bottom portion into place first. Press down on top of grille until top portion snaps into place. What if my refrigerator rocks? B 4. Check with level to verify 6 mm tilt to the back for proper door closure. If refrigerator is aligned and stable, replace toe grille.
Turn rear adjustment screw clockwise to raise rocking corner. Replace toe grille. 4