Required accessories and tools Supplied accessories Tools Installation instructions Operating instructions Installation kit Cordless screwdriver Optional accessories T20 Torx-bit magnetic holder Installation accessories for Side-by-Side installation For permanent connection of two individual appliances, e.g. Freezer next to Refrigerator. Lateral additional heating If the gap between the appliances is less than 6" (160 mm). T20 Torx screwdriver Connecting element for furniture doors 5 / 16 " (8 mm) socket wrench For connection of two door panels (see explanation in Section “4. Preparing the furniture doors”). Can be used for standard height door panels without further preliminary work.
Various size drills Miscellaneous Stepladder Open end wrench 1 / 2 " (SW 13 mm) Dolly, hand truck Hammer drill for drilling holes in wall or floor Bits according suitable for material and in different sizes Multigrip pliers Wooden beam (cross section min. 3" x 4") as an alternative tip protection, length according to the width of the installation niche Adjustable wrench Wooden screws in different sizes Thin plywood sheet, particle board or cardboard to protect the floor from damage Cutter with adjustable blade Suitable material for covering and protecting furniture (e.g. protective sheets) Metal tape measure, folding ruler Adhesive tape Note:
Before using, check whether the removed adhesive tape leaves adhesive residue on the work surfaces! Otherwise do not use on high-quality work surfaces. Square 2' (60 cm) and 4' (1 ,2 m) spirit levels Level, min. 4' (1 ,2 m) long 10