Installation instructions The following installation instructions describe the installation steps for various appliance types. Appliance width Weight (empty) approx. Therefore the diagrams may be a general representation of your appliance. Particular reference is made to special installation steps for individual appliance types.. Wine storage cabinet 18" (45.1 cm) 242 lbs (109 kg) Freezer 30" (75.6 cm) * 322 lbs (145 kg) Wine storage cabinet 24" (60.3 cm) 291 lbs (131 kg) 1. Check the installation niche * without water and ice dispenser CAUTION Note: Use the following check list for a safe and trouble free installation. Do not install the appliance if it is visibly damaged.
If in doubt, contact your dealer. Check appliance for damage in transit. 1. Check the floor. To avoid floor damage: 1. Remove the packaging carton and be careful not to damage the surface of appliance. 2. Check the dimensions of the installation niche, see “Dimensions of the installation niche”. See section on “Installing the appliance/Floor”. 2. Place packaging cardboard or plywood under the appliance. 3. Check that the installation niche is square. 3. Remove accessories from the outside of the appliance. 4. Check location of the socket. See section on “Electrical connection” and in the section on “Dimensions of the installation niche”.
Save adhesive tape which was used to attach the supplied accessories to the appliance. It can be used subsequently for attaching an edge protection to the installation niche walls (see section on “ A / 3. Attaching the edge protectors”). 5. Check location of the water connection (only for appliances with ice maker). See section on “Water connection” and in the section on “Dimensions of the installation niche”. 6. Check attachment of the adjacent cabinet/fixtures. All cabinet parts in the vicinity of the appliance must be connected securely to the wall. 4. Remove transportation protection devices (a) and lift appliance off the pallet – appliance is very heavy! 7.
Check that adjacent cabinet/fixtures have adequate clearance (door opening angle). a 2. Removing the packaging WARNING Risk of personal injury and damage to the appliance! 5. Carefully open the appliance – risk of tipping over – and remove accessories and installation materials from inside the appliance. Close the door again. The appliance could tilt over when unpacking. The appliance could tilt over when the appliance door is opened. The appliance is very heavy. Data relating to the weight when empty is found in the following table:
Do not remove transportation safety devices which protect the shelves and storage compartments inside the appliance until the installation is complete, otherwise the parts may be damaged. Note: Appliance width Weight (empty) approx. Refrigerator 24" (60.3 cm) 291 lbs (131 kg) Refrigerator 30" (75.6 cm) 322 lbs (145 kg) Freezer 18" (45.1 cm) * 242 lbs (109 kg) Freezer 24" (60.3 cm) * 291 lbs (131 kg) 11