4 Press the battery into place. 5 Replace the battery cover, and turn the D-ring clockwise. Charging the Handheld Device NOTICE To prevent corrosion, thoroughly dry the mini-USB port, the weather cap, and the surrounding area before charging or connecting to a computer. Б on the charging clip. 3 Plug the other end of the power cable into a power source. 2 Plug the small end of the power cable into the mini-USB port You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about 2 hours. NOTE:
The device will not charge when it is outside the temperature range of 32° to 104°F (0° to 40°C). 1 Lift the weather cap А The status LED is solid red when the collar is charging. 4 After the status LED turns solid green, remove the charging clip from the collar. Turning On the Devices On the handheld device, select the Power key. On the collar, select the Power key. The collar beeps and the status LED blinks green when the collar is turned on. Turning Off the Devices On the handheld device, hold the Power key. On the collar, hold the Power key until the status LED turns red, about 3 seconds, and then release the Power key. Acquiring Satellite Signals Before you put the collar on your dog, both the collar and handheld device must acquire satellite signals. Acquiring satellites can take a few minutes. 1 Go outdoors to an open area. 2 Turn on both devices ( page 2 3 Select the Power key. Б on the device. 3 Plug the other end of the power cable into an appropriate 2 Plug the small end of the power cable into the mini-USB port power source. The GPS signal strength of the handheld device is listed in the upper-right corner. When the collar has acquired satellite signals, the status LED flashes a double-blink or triple-blink in green. Charging the Dog Collar Device NOTICE To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip. Before you put the collar on the dog, remove the charging clip. If you do not remove the clip, it may become detached from the collar and become lost. Using the Touchscreen Select to open the application drawer. Select to open a menu. Select to close the page and return to the previous page. Select to return to the previous page. Select to save changes and close the page. Select and to scroll. Select You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about two hours. The device will not charge when outside the temperature range of 32° to 104°F (0° to 40°C). 1 Snap the charging clip А onto the device. to search by name. Locking the Touchscreen You can lock the screen to prevent inadvertent screen touches. 1 Select the Power key. 2 Select . Unlocking the Touchscreen 1 Select the Power key. 2 Select . 2 Getting Started