Table 7. Control panel error messages Message Cause Solution MEMORY LOW. ONLY 1 COPY. PRESS [STOP] The product completed making one copy. The remaining copies have been canceled because of low product memory. Press E NTER /M ENU to clear the error. Use the HP LaserJet Director to make multiple copies of large documents, or break the job into smaller jobs containing fewer pages. MEMORY LOW. [STOP] TO CANCEL. The product memory has been almost completely filled. Allow the product to finish the job or press S TOP /C LEAR to cancel the job. NO DIAL TONE. The product could not detect a dial tone. Unplug the telephone cord from both the product and the wall and replug the cord.
Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. See “Changing the detect dial tone setting” in the online user guide. Also see chapter 6, “Troubleshooting.” NO DOCUMENT SENT The fax forwarding setting is on and the product unsuccessfully received a fax because of low memory or some other reason. The product deleted the incomplete received data before attempting to forward the deleted data. Print the faxes in memory and have the sender resend the missing page(s) of the document.
NO FAX DETECTED The product answered the incoming call but could not determine that the caller was a fax machine. Allow the product to retry sending the fax. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. See chapter 6, “Troubleshooting.” NO FAX PAGES IN MEMORY TO REPRINT The product attempted to execute “Reprint Last Fax” when nothing was in memory. Receive a fax before attempting to use this option. NOT ENOUGH MEMORY. TRY AGAIN LATER There is not enough memory to start a new job. Wait until the current job is finished before starting a new job.
40 Chapter 2 - Installation and operation EN