KX11 PHEV 2023 Engine Engine control system (DHE15-ESZ) 2-33 1 Install the throttle unit and connect the harness connector A of the throttle unit. Caution 1. Before assembly, check the mounting surface on both sides of the throttle unit for scratches and other defects. If any, replace them before assembly. 2. Throttle body sealing gasket can be used without deformation or damage. 2 Tighten the three fixing bolts 1 of the water-cooled intercooler subassembly, then tighten the two fixing bolts 2 of the water-cooled intercooler subassembly, and retighten them once in order after tightening them all. Torque of Bolt 1: 10 N·m Torque of Bolt 2:
23 N·m Caution Before assembly, make sure that the throttle body sealing gasket on the intake manifold and water- cooled intercooler subassembly is in place, and check that the gasket is free from scratches, oil and dirt. 3 Install and tighten the two fixing bolts 3 of the water- cooled intercooler subassembly. Torque of Bolt 3: 24 N·m 4 Install the engine trim cover assembly. 5 Connect the negative cable of battery. 6 Use the GLDS diagnostic program. On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the software flash operation. 7 Close the engine compartment cover.
2.2.6.7 Replacement of Air Pressure and Temperature Sensor 1 Removal Procedure KX11 PHEV 2023 2-34 Engine control system (DHE15-ESZ) Engine