Warning ！ Refer to "Warnings regarding battery disconnection" in " Warnings and Precautions ". 1 Open the engine compartment hood. 2 Disconnect the negative cable of battery, refer to Procedures for disconnecting and connecting battery cable . 3 Disconnect the harness connector A of the air pressure and temperature sensor 1. 4 Remove the fixing bolt 1 of the air pressure and temperature sensor 1 and take off the air pressure and temperature sensor 1. Installation Procedure 1 Install the air pressure and temperature sensor 1 and tighten the fixing bolt 1 of the air pressure and temperature sensor 1. Torque: 10N·m Caution 1.
Before installing the sensor, dip a grease stick into an appropriate amount of engine oil and apply it evenly to the chamfer of the sensor mounting hole. 2. Before assembly, check sealing rings for damage or missing. If any, replace them. 3. Storage, transportation and assembly processes must be protected against static electricity and touching the sensor pins is prohibited. 4. Do not plug or unplug any sensor with electricity during the energizing operation such as cold or hot test. 2 Connect the harness connector A of the air pressure and temperature sensor 1. 3 Connect the negative cable of battery.
KX11 PHEV 2023 Engine Engine control system (DHE15-ESZ) 2-35 4 Use the GLDS diagnostic program. On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the 5 Close the engine compartment cover. software flash operation. 2.2.6.8 Replacement of VVT Solenoid Coil