3 Tutorial 4 — Using Measurement Tools in an Inspection Advanced Tool Tutorials 32. In the Properties pane, set the following Circle Radius Tolerance parameters: – Input Datum — LeastSquaresCircleFit.Radius – With Tolerance — 5% Nominal 33. Minimize the Step Tree Editor. 34. Click . On the properties page, observe that the Nominal Distance is set to be the radius value calculated by the LeastSquaresCircle Fit step. The Tolerance +/- is set to the value that is 5% of the Nominal Distance. This is because the parameter With Tolerance is set at 5% Nominal. 35. Minimize the Step Tree Editor. 36. Highlight Pin to Pin Distance. 37. Click .
Observe that Pin to Pin Distance is highlighted and Circle Radius tolerance has run successfully, as indicated by the green check mark. 38. In the Properties (Figure 3–25), set Graphics Level to Show Graphics. FIGURE 3–25. Select Reference Button Getting Started with Visionscape GigE Cameras 3-35