9. The printer will then check the Serial Number and Part Number and display the information on the Front Panel. Press any key to continue the test: If the Serial Number does not have assigned a correct 10 character format or the Part number does not have assigned a correct 6 character format, a fail message will appear on the Front Panel. In this case, re-enter in to the Service Tests submenu and use the diagnostic “13. Error 71:19 Recovery” to set the correct Serial Number (refer to page 126). 10. A message will appear on the Front Panel asking whether you would like to check the Sausalito. Select Yes or No by using the Up and Down keys and press Enter to confirm your selection.
If you select No , the printer skips this test and goes to the next one: 11. If you select Yes , the Printer will check the Sausalito PCI PCA and the following messages will be displayed on the Front Panel: • Starting CDS • Checking Sausalito PCI. • Starting Sausalito. • Checking Impact memory • Checking Gauntlet memory. If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. Tests and Utilities 12. A message will appear on the Front Panel asking whether you would like to check the Power Supply.
Select Yes or No by using the Up and Down keys and press Enter to confirm your selection. If you select No , the printer skips this test and goes to the next one: 13. If you select Yes , the Printer will check the Power Supply Unit and the following messages will be displayed on the Front Panel: • Starting Sausalito. • Starting Tests GPIO. • Starting Tests Encoder. If there is a failure at this point, the Front Panel will display System Error Code XX.X:XX . For more information on troubleshooting this error code, refer to page 47. Entering the Service Tests Menu 107