16. A message will appear on the Front Panel stating that the delSol has been detected and asking whether you would like to Continue. Press any key to continue: If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. • Checking Vacuum Fans. • Switching on Vacuum Fans. • Testing Vacuum Fans. • Switching off Vacuum Fans. 17. At this stage the Front Panel displays the results for the test of the vacuum fans and asks whether you would like to Continue. Press any key to continue:
If there is a failure at this point, the Front Panel will display either System Error Code 01.0:10 or System Error Code 01.1:10 . For more information on troubleshooting either of these error codes, refer to page 47. 18. A message will appear on the Front Panel asking whether you would like to check the Interconnect. Select Yes or No by using the Up and Down keys and press Enter to confirm your selection. If you select No , the printer skips this test and goes to the next one: Tests and Utilities 19. If you select Yes , the Printer will check the Interconnect PCA and the following messages will be displayed on the Front Panel: • Starting CDS.
If there is a failure at this point, the Front Panel will display System Error Code 79:03 . For more information on troubleshooting this error code, refer to page 72. • Getting unit config. If the current Part Number is not in the correct 6 character format, the Front Panel will display a fail message. In this case, re-enter in to the Service Tests submenu and use the diagnostic “14.2 Error 71:19 Recovery” to set the correct Serial Number (refer to page 126). • Starting Tests GPIO. If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. Entering the Service Tests Menu 109