Belt Assembly Removal WARNING!: Switch off the printer and remove the power cable. 1. Remove the Right Cover ⇒ See page 264 . 2. Remove the Left Cover ⇒ See page 270. 3. Remove the Top Cover ⇒ See page 277 . 4. Remove the Encoder Strip ⇒ See page 331 . 5. Remove the Carriage Assembly ⇒ See page 339 . 6. Release the Belt from the bottom of the Carriage Assembly. NOTE: After installing the NEW Belt Assembly, make sure you perform the following Service Utility: Removal & Installation • Reset life counter scan cycles belt ⇒ Chapter 4. Belt Assembly 345