Media-Axis Motor Removal WARNING!: Switch off the printer and remove the power cable. 1. Remove the Left Cover ⇒ See page 270 . 2. Remove the Rear Door ⇒ See page 283 . 3. Remove: • For the 42-inch model, the Left Connector Cover ⇒ See page 287. • For the 60-inch model, the Electronics Module Extension ⇒ See page 288. 4. Disconnect the Media-Axis Motor cable from the PrintMech PCA. Removal & Installation 5. Detach the clamp of the ferrite core of the Media-Axis Motor cable from the printer chassis. Media-Axis Motor 349