6. Remove the T-15 screws ( Type R ) identified (A) and loosen the T-15 screws ( Type R ) identified (B) that secure the Media-Axis Motor. B A 7. Remove the Media-Axis Motor Bracket. Removal & Installation 8. Remove two T-20 screws ( Type B ) that secure the Media-Axis Motor Bracket. 9. Remove the Media-Axis Motor from the Printer. NOTE: When reinstalling the parts, make sure you apply the grease (included with the support part) to the gears. NOTE: After installing the NEW Media-Axis Motor, make sure you perform the following Service Calibration: • Paper Advance Calibration ⇒ Chapter 5. 350 Chapter 8 Removal & Installation