Table 37. Printer messages (continued) Control panel message Explanation Recommended action ENV FEEDER LOAD [TYPE] [SIZE] A job has been sent to the envelope feeder and the feeder is empty, the wrong size is loaded in the feeder, or the type and size are set incorrectly on the control panel. 1. Load the requested envelope type and size into the envelope feeder. 2. Make sure the envelope size and type are set correctly from the paper-handling menu in the printer control panel. 3. Press G O if the desired envelope is already loaded in the feeder. 4. Press -V ALUE + to scroll through other available types and sizes. 5. Press S ELECT to accept the alternate type or size.
ENVELOPE FEEDER SIZE = [xxxxx] The printer is asking what size envelopes have been loaded in the envelope feeder. In response, you can take either of the following actions: 1. Press S ELECT to accept the current envelope size. 2. Press -V ALUE + to change the size and then press S ELECT to accept the new size. If you do not press any buttons, the message disappears in about one minute. Note Changing the size here changes the default for the envelope- feeder size in the paper-handling menu. ENVELOPE FEEDER TYPE = [xxxxx] The printer has received a job under the following conditions: You can take either of the following actions: 1. Press S ELECT to accept the paper type and then press G O . 2.
Press +V ALUE - to change the type, press S ELECT to accept the new type, and then press G O to continue. ! The envelope type the job requested is not available in the printer. ! Envelopes have been placed in the envelope feeder (thus triggering the paper sensor). FLASH DEVICE FAILURE The flash DIMM had a critical or fatal failure. 1. Reseat the flash DIMM and ensure it is locked into place. 2. Remove the flash DIMM and replace it with a new one. FLASH FILE OPERATION FAILED The requested operation could not be performed (for example, attempting to download a file to a nonexistent directory). 1. Check the file name and the directory name. 2. Reseat the flash DIMM. 3. Retry the operation.
EN Chapter 7 Troubleshooting 197