SEC/DIV 500μs Measure On or Off Off Source CH1 Trigger (Edge) Slope Rising Mode Auto Level 0.00v Bandwidth Limit Unlimited Vertical System, All Channels Coupling AC Probe Attenuation 1X Position 0.00div (0.00V) VOLTS/DIV 1V The following settings do not change when you recall default settings. Language Option Saved Settings Saved waveform Saved Reference Waveforms Calibration Data Horizontal System Press Time button to enter horizontal system menu, use the direction keys to change the horizontal scale (time base) and the horizontal trigger position. When you change the horizontal scale, the waveform will expand or contract to the screen center. 1. SEC/DIV Knob:
Used to change the horizontal time scale so as to magnify or compress the waveform horizontally. If the waveform acquisition is stopped (by using button), press Time button and Up or Down buttons to expand or compress the waveform. 2. Horizontal Position Knob: Used to control the trigger position against the screen center. Press Time button and Right or Left buttons to move the waveform right or left. The key resolution vary according to time base. Press "AUTO" key can make the horizontal position return to zero. 3. Mode: Y-T, X-Y, Roll, Scan. Y-T : YT format shows the vertical voltage in relation to time (horizontal scale). Press Time->Mode to set. X-Y :
The XY mode is used to analyze phase differences, such as those represented by Lissajous patterns. The format plots the voltage on CH1 against the voltage on CH2, where CH1 is the horizontal axis and CH2 is the vertical axis. You may view the same waveform in XY mode. To perform this operation, stop the acquisition and press Time->Mode to change the display mode to X-Y . 12