Recall Recall the waveform. To save the waveform, follow these steps: 1. Press F1 to select the storage position of the waveform. 2. Press F2 to save the waveform data to the specified position. Also users can long press button to enter, and select F4->F2 (Data Save) as shortcut keys. Press button one time to save the current waveform data. 3. Press F3 , recall the saved waveform. The waveform can be enlarged or reduced in the Channel or Time menu by using the direction keys. Attention: 1. Waveform storage can not only save the waveform of the current channel, but also save the current state settings at the same time. 2.
Users can permanently store 6 waveforms in the oscilloscope memory and rewrite them at any time. Reference Waveform The REF channel is used to display the reference waveform, which can compare the actual waveforms with the reference waveforms so as to find out the differences. Press Menu button to enter, and select Ref to enter reference Waveform menu. REF Menu Table Position Ref-A Ref-B The REF waveform is saved to the oscilloscope Ref-A or Ref-B. Enable On Off Open the REF waveform. Close the REF waveform. Source CH1 CH2 Select CH1 to save as a REF waveform. Select CH2 to save as a REF waveform Save Save the REF waveform. To save the reference waveform, follow these steps: 1.
Press F1 to select the position of the reference waveform. 2. Press F2 to open the REF channel. 3. Press F3 to select the source to CH1 (or CH2), and only select the open channel. 4. Press F4 to save the current waveform to the specified location.. Measurement Scale measurement 15 Menu Setting Description